Hello there ;
mdvbapi_v0.15 dll works fine.When I switch to PowerVU channels on the Astra 4.9 satellite, I watch it for 10 minutes. OSCam crashes. PowerVU dll is conflicting with mdvbapi dll.
Hello there ;
Fixed possible crash on closing the plugin
Changed config folder destination to %ALLUSERSPROFILE%\mdvbapi (example: C:\ProgramData\mdvbapi).
Existing config mdvbapi.ini or mdvbapi.log is getting moved to the new config folder on the first start.
Changed log entries for DVBLink
Fixed filter for data with a length of 184 bytes
Added extended CW API (PowerVu, DES & AES) (only usable for DVBViewer - untested!)
Microsoft Visual C++ 2017 Redistributable Package (x86) is needed!
Added some speed improvements for the SSE2 version.
Added AVX2 (256 bit) version (this is a decoding boost against the SSE2 version)
Finished CW API (PowerVu, DES & AES), thx to lnj
MPC-VR seems to be a very nice renderer, and certainly use lower resources than madVR. I tried to render a file in GraphEdit (graphstudionext.exe) and the render does not show any video window (tested with stable version 0.5.2.1607 and nightly build 0.5.3.1706). In MPC-HC is working OK.
That's why I've recommended MPC-VR for implementation in AltDVB.
I tried MPC-VR v0.4.10.1542 x64 with same result in graphstudionext64.exe
It's a pity I don't know.
I'm not programmer but I know it took couple of days while SmartDVB has been successfully tried to implement MPC-HC/BE sources in his app SmartDVB
Hi,altxro wrote: ↑Thu May 06, 2021 4:46 pm Thank you, Crazycat !
Hint: After installation, If the library Dev_Bda2Driver does not appear in the AltDVB selector list, please install Visual C++ 2008 redistributable:
Thanks a lot for your reply, and for keeping alive this great free viewer.Mr. Orbita wrote: ↑Mon Jun 07, 2021 3:32 am I'm afraid that for DVBSky devices DiSEqC is not yet supported on main Dev_BdaDriver.int, that's why you cannot use it on DVBSky device for multiple satellite positions.
For issue with image breakup on Dev_Bda2Driver.int from CrazyCat - please check Settings -> General and try to slow down Signal update interval. Please try to use at beginning some very low value, eg. 10000 ms. It will extremely slow down reading signal level & quality (to 10s), but might show if this is the reason.
Also you can try to check Process Priority and set it to High, but firstly please check Signal update interval.